Todas as categorias
Controlo de acessos
Altronix Controlador de alimentação para controlo (eFlow4NA8V)

Altronix

Altronix Controlador de alimentação para controlo (eFlow4NA8V)

Por encomenda

  • EstadoNovo
  • Garantia1 ano
  • MarcaAltronix
  • ReferênciaeFlow4NA8V
  • CódigoSL-04555
  • EntregaLuanda, combinada no pedido

Descrição

Access Power Controller w/ Power Supply/Charger, 8 Fused Relay Outputs, 12/24VDC, 4A, Aux Output, FAI, 220VAC, BC400 Enclosure

Altronix eFlow4NA8V unit distribute and switch power to access control systems and accessories. It converts a 220VAC 50/60Hz input into eight (8) independently controlled 12VDC or 24VDC fuse protected outputs with a total of 4A continuous supply current. These power outputs can be converted to dry form "C" contacts. Outputs are activated by an open collector sink or normally open (NO) dry trigger input from an Access Control System, Card Reader, Keypad, Push Button, PIR, etc. Unit will route power to a variety of access control hardware devices including: Mag Locks, Electric Strikes, Magnetic Door Holders, etc. Outputs will operate in both Fail-Safe and/or Fail-Secure modes. The FACP Interface enables Emergency Egress, Alarm Monitoring, or may be used to trigger other auxiliary devices. The fire alarm disconnect feature is individually selectable for any or all of the eight (8) outputs.

Ver mais informaçõesVer menos

Ficha técnica

  • Modelo: eFlow4NA8V
  • Entrada: Input 220VAC 50/60Hz, 2.1A.
  • Opções de entrada da fonte de alimentação: a) One (1) common power input for ACM8 and lock power (factory installed).; b) Two (2) isolated power inputs - One (1) to power the ACM8 and one (1) for lock ac
  • Opções de entrada: a) Eight (8) normally open (NO) inputs.; b) Eight (8) open collector inputs.; c) Any combination of the above.; ACM8 board main fuse is rated at 10A.
  • Saída: 12VDC or 24VDC outputs @ 4A supply current.; Power-limited outputs.; Eight (8) independently trigger controlled outputs.
  • Opções de saída: a) Eight (8) Fail-Safe filtered power outputs.; b) Eight (8) Fail-Secure filtered power outputs.; c) Eight (8) form "C" relay outputs (rated @ 5A /24VDC or VAC)
  • Corte do alarme de incêndio: Fire Alarm disconnect (latching or non-latching) is individually selectable for any or all of the eight (8) outputs.
  • Opções de entrada de corte do alarme de incêndio: a) Normally open (NO) or normally closed (NC) dry contact input.; b) Polarity reversal input from FACP signaling circuit.; Alarm output relay indicates that FAC
  • Supervision: AC fail supervision (form "C" contacts).; Battery fail & presence supervision (form "C" contacts).; Low power shutdown. Shuts down DC output terminals if batter
  • ACM8 Access Power Controller: Red LEDs indicate outputs are triggered (relays energized).; Green LED indicates FACP disconnect is triggered.
  • Placa de alimentação eFlow: AC input and DC output LED indicators.
  • Carregamento de bateria: Built-in charger for sealed lead acid or gel type batteries.; Maximum charge current: 1.54A.; Automatic switch over to stand-by battery when AC fails. Transfer
  • Temperatura: Operating: 0° C a 49° C (32° F a 120° F).; Storage: - 20° C a 70° C ( - 4° F a 158° F).; Relative Humidity: 85% +/- 5%.
  • BTU/Hr. (approx.): 12VDC: 25 BTU/Hr.; 24VDC: 40 BTU/Hr.
  • Dimensões: 310.6 mm W x 393.7 mm H x 114.3 mm D
Fale connosco