SMARTLOCK — Sistemas de Segurança0
LojaSMARTLOCK
Todas as categorias
Controlo de acessos
Altronix Controlador de energia para controlo de acessos (AL1012ACMCB220)

Altronix

Altronix Controlador de energia para controlo de acessos (AL1012ACMCB220)

Por encomenda

  • EstadoNovo
  • Garantia1 ano
  • MarcaAltronix
  • ReferênciaAL1012ACMCB220
  • CódigoSL-04475
  • EntregaLuanda, combinada no pedido

Produtos relacionados

Descrição

Access Power Controller w/ Power Supply/Charger, 8 PTC Class 2 Relay Outputs, 12VDC @ 10A, FAI, 220VAC, BC400 Enclosure

AL1012ACMCB220 converts a nominal 220VAC 50/60Hz input into eight (8) independently controlled 12VDC Fail-Safe and/or Fail-Secure outputs with a total of 10A continuous supply current. Outputs are activated by an open collector sink or normally open (NO) dry trigger input from an Access Control System, Card Reader, Keypad, Push Button, PIR, etc. This unit will route power to a variety of access control hardware devices including Mag Locks, Electric Strikes, Magnetic Door Holders, etc. The outputs will operate in both Fail-Safe and/or Fail-Secure modes. This unit is designed to be powered by one common power source (factory installed) which will provide power for both the board operation and locking devices, or two (2) totally independent power sources, one (1) providing power for board operation and the other for lock / accessory power. The FACP Interface enables Emergency Egress, Alarm Monitoring, or may be used to trigger other auxiliary devices. The fire alarm disconnect feature is individually selectable for any or all of the eight (8) outputs.

Ver mais informaçõesVer menos

Ficha técnica

  • Modelo: AL1012ACMCB220
  • Entrada: Nominal 220VAC (range 198VAC - 256VAC) 50/60Hz, rated @ 1.0A.
  • Opções de entrada da fonte de alimentação: a) One (1) common power input for ACM8CB and lock power (factory installed).; b) Two (2) isolated power inputs - One (1) to power the ACM8CB and one (1) for loc
  • Opções de entrada: a) Eight (8) normally open (NO) inputs.; b) Eight (8) open collector inputs.; c) Any combination of the above.
  • Saída: 12VDC @ 10A supply current.; Eight (8) independently controlled Fail-Safe and/or Fail-Secure power outputs (auto-resettable).; Eight (8) auxiliary power outputs
  • Características: Fire Alarm disconnect (latching or non-latching) is individually selectable for any or all of the eight (8) outputs.
  • Opções de entrada de corte do alarme de incêndio: a) Normally open (NO) or normally closed (NC) dry contact input.; b) Polarity reversal input from FACP signaling circuit.; Alarm output relay indicates that FAC
  • Indicadores visuais: Red LEDs indicate outputs are triggered (relays energized).; Green LED indicates FACP disconnect is triggered.; AC input and DC output LED indicators.
  • Carregamento de bateria: Built-in charger for sealed lead acid or gel type batteries.; Automatic switch over to stand-by battery when AC fails.; Zero voltage drop when unit switches ove
  • Temperatura: Operating: 0° C a 49° C (32° to 120°F).; Storage: - 20ºC to 70ºC ( - 4ºF to 158ºF).; Relative Humidity: 85% +/- 5%.; BTU/Hr. (approx.): 61 BTU/Hr.
  • Dimensões: 310.6 mm W x 393.7 mm H x 114.3 mm D

Mais na mesma categoria

Fale connosco