Altronix
Controlo de acessos
Altronix Access Power Controller w/ Power Supply/Charger, 8 PTC Class 2 Relay Outputs, 12VDC, 10A, (eFlow102NA8DV)
Por encomenda
- EstadoNovo
- Garantia2 anos (fabricante)
- MarcaAltronix
- ReferênciaeFlow102NA8DV
- CódigoSL-04586
- EntregaLuanda, combinada no pedido
Access Power Controller w/ Power Supply/Charger, 8 PTC Class 2 Relay Outputs, 12VDC, 10A, Aux Output, FAI, 220VAC, BC400 Enclosure
Access Power Controller w/ Power Supply/Charger, 8 PTC Class 2 Relay Outputs, 12VDC, 10A, Aux Output, FAI, 220VAC, BC400 Enclosure
eFlow102NA8DV distributes and switches power to access control systems and accessories. It converts a 220VAC 50/60Hz input into eight (8) independently controlled 12VDC PTC protected outputs. These power outputs can be converted to dry form "C" contacts. Outputs are activated by an open collector sink or normally open (NO) dry trigger input from an Access Control System, Card Reader, Keypad, Push Button, PIR, etc. Unit will route power to a variety of access control hardware devices including: Mag Locks, Electric Strikes, Magnetic Door Holders, etc. Outputs will operate in both Fail-Safe and/or Fail-Secure modes. The FACP Interface enables Emergency Egress, Alarm Monitoring, or may be used to trigger other auxiliary devices. The fire alarm disconnect feature is individually selectable for any or all of the eight (8) outputs.
Ficha técnica
- Modelo: eFlow102NA8DV
- Input: Input 220VAC 50/60Hz, 2.1A.
- Power supply input options: a) One (1) common power input for ACM8CB and lock power (factory installed).; b) Two (2) isolated power inputs - One (1) to power the ACM8CB and one (1) for loc
- Input options: a) Eight (8) normally open (NO) inputs.; b) Eight (8) open collector inputs.; c) Any combination of the above.; ACM8CB board main fuse is rated at 10A.
- Output: 12VDC output @ 10A supply current.; Power-limited outputs.; Eight (8) independently trigger controlled outputs.
- Output options: a) Eight (8) Fail-Safe filtered power outputs.; b) Eight (8) Fail-Secure filtered power outputs.; c) Any combination of the above.; Eight (8) unswitched filtere
- Fire Alarm Disconnect: Fire Alarm disconnect (latching or non-latching) is individually selectable for any or all of the eight (8) outputs.
- Fire Alarm disconnect input options: a) Normally open (NO) or normally closed (NC) dry contact input.; b) Polarity reversal input from FACP signaling circuit.; Alarm output relay indicates that FAC
- Supervision: AC fail supervision (form "C" contacts).; Battery fail & presence supervision (form "C" contacts).; Low power shutdown. Shuts down DC output terminals if batter
- ACM8CB Access Power Controller: Red LEDs indicate outputs are triggered (relays energized).; Green LED indicates FACP disconnect is triggered.
- eFlow Power Supply Board: AC input and DC output LED indicators.
- Battery Charging: Built-in charger for sealed lead acid or gel type batteries.; Maximum charge current: 1.54A.; Automatic switch over to stand-by battery when AC fails. Transfer
- Temperature: Operating: 0° C to 49° C (32° F to 120° F).; Storage: - 20° C to 70° C ( - 4° F to 158° F).; Relative Humidity: 85% +/- 5%.
- BTU/Hr.: 12VDC: 61 BTU/Hr.
- Dimensões: 310.6 mm W x 393.7 mm H x 114.3 mm D
